asked in Technical problem by

hello, this is the 2nd o11d distro that i have purchased new. the first one was leaking between the plexiglass. was included with the titan. i returned to microcenter. 

this new front distro is leaking through the pump down the power line. what’s going on with these things???

https://imgur.com/a/52PWpzk

5 Answers

answered by (106k points)
Dear Customer,

Sorry to hear that. Did you ever use the air leaking tester before filling water? How much air pressure and how long did you keep the air pressure in your whole loop?
answered by (180 points)
no i didn’t use an air leak tester. just ran the system with distilled water and just the pump powered. the leak came from the pump around the 18th hour of running the loop
answered by (106k points)
Dear Dysect,

Thanks for your response.
Would you send the receipt of this product to follows email address?
We will check with Micro Center and reply to you, thank you.

[email protected]
answered by (180 points)
i exchanged for a new one, i just finished building the machine again. hopefully everything is fine with the new one.
answered by (200 points)

It sounds like you're experiencing some frustrating issues with your O11D distro. Leaks in water cooling systems can be concerning, especially when they occur between components or through connectors. Here are a few potential reasons why you might be encountering these problems:

1. **Faulty Seals or Connections**: Leaks can occur if the seals between components, such as the plexiglass panels or fittings, are not properly sealed or tightened. Check to ensure all fittings are securely tightened, and consider using additional sealant if necessary.

2. **Quality Control Issues**: If you've encountered multiple leaks with different units, it's possible that there may be quality control issues with the manufacturing process of the distros. This could include defects in materials, improper assembly, or other issues.

3. **Installation Errors**: Improper installation can also lead to leaks. Make sure you're following the manufacturer's instructions carefully when installing the distro, including proper placement, alignment, and tightening of fittings.

4. **Pressure Build-Up**: Excessive pressure within the cooling system can cause leaks. Ensure that your pump and other components are functioning correctly and that the system is properly bled to remove any air pockets.

5. **Compatibility Issues**: It's essential to ensure that all components in your water cooling loop are compatible with each other and with the distro. Mixing incompatible materials or components can lead to leaks or other problems.

Given that you've experienced issues with multiple units, it might be worth reaching out to the manufacturer or retailer for further assistance. They may be able to provide troubleshooting tips or offer a replacement if the issues persist. Additionally, consider seeking advice from online communities or forums dedicated to water cooling enthusiasts, as they may have insights or suggestions based on similar experiences.

https://bazarmotoriran.ir/

 

 

 

 

 

...