asked in Product related by
I need the measurements of the terminal area of the water block I need to see if it matches the terminal manifold i already have. the 3 screws in top that hold the terminal port, their spacing distance between them. the distance between center of each tube inlet/outlet might help too. thanks

1 Answer

answered by (76.7k points)
Dear Travis,

About the spacing distance of the 3 screws on top, please refer to the installation guide, and check with the PCB holes, the distance is the same.
About the distance between the center of each tube inlet/outlet, would you send an email to follows address, we will show you in the picture.
shopservice@bitspower.com.tw

 

 

 

 

...